DATA TECHNOLOGY CORPORATION DTC5287CR, DTC5287I, DTC7287 Data bus: 16-bit, ISA Size: Full-length, full-height card Hard drives supported: Two RLL ST506/412 drives with 17,32, or 60 sector mapping Floppy drives supported: Two 360KB, 720KB, 1.2MB, or 1.44MB Sector interleave: DTC5287CR: 1:1 DTC5287i: 2:1 DTC7287: 1:1 [Image] CONNECTIONS Function Location 34-pin data cable connector-floppy drive J1 34-pin control cable connector-hard drive J2 20-pin data cable connector-drive 0 J3 20-pin data cable connector-drive 1 J4 4-pin connector-drive active LED J5 USER CONFIGURABLE SETTINGS Function Location Setting » Floppy drive data transfer rate W4 open is 500KHz Floppy drive data transfer rate W4 closed is 250KHz » Hardware drive select mode W5 closed (drive number is driven directly to the interface) Firmware drive select mode W5 open (drive number is intercepted by controller firmware) » Auto-deselect enabled W6 closed Auto-deselect disabled W6 open » Floppy drive precompensation W7 open scaled by data rate: 500KHz=125ns, 300KHz=208ns, 250KHz=250ns Floppy drive precompensation is W7 closed 125ns » Factory configured - do not alter W8 closed » BIOS address is C800h W9 open BIOS address is D800h W9 closed » BIOS enabled W10 closed BIOS disabled W10 open HARD DRIVE PORT ADDRESS Address W2 W3 » Port addresses are 1F0-1F7 open open 3F2-3F7h Port addresses are 170-177 closed closed 372-377h